Installing with a Hardware (HASP) Key
Insert your hardware key (a small USB drive) into a USB port on the computer you intend to use eXtyles on BEFORE trying to install eXtyles.
First-time installation
Download the HASP drivers from http://www.extyles.com/drivers/HASP_drivers_latest.zip.
Make sure your hardware key is inserted into a USB port on the PC.
Unzip the downloaded drivers from step 1.
Inside the resulting folder Sentinel_HASP_Run-time_setup, double click the file HASPUserSetup.exe.
Reboot your PC. At this point, a red light should be glowing on the end of the hardware key.
You can then continue to install eXtyles as described below.
On this page
Applies to:
Only applies to certain configurations of:
Installing eXtyles
Make sure your USB key is plugged into your computer and the red light is on.
Double-click the eXtyles installation file that you downloaded from the provided URL (this file will probably look something like eXtylesOrganizationNumber.exe).
Follow the step-by-step instructions provided within the InstallShield Wizard dialog.
Enter your user information to finish installing eXtyles. Your serial number will be on the tag attached to the hardware key and will start with EX or EXT. (If your tag has been removed or your serial number is no longer readable please contact eXtyles Support.)
If applicable, install any patch files according to the instructions provided by Inera (these vary depending on the customer and patch type).
Start Microsoft Word.
Accept any security alert to allow macros signed by Inera Inc. to run.
You should see the eXtyles menu added to the Word ribbon. If you do not see the eXtyles tab, please visit our FAQs or contact eXtyles technical support.