Installing with a Hardware (HASP) Key

Insert your hardware key (a small USB drive) into a USB port on the computer you intend to use eXtyles on before trying to install eXtyles.

First-time installation

The first time you install your keyed version of eXtyles you will first need to make sure that you have HASP drivers installed on your machine.

Download the HASP drivers from http://www.extyles.com/drivers/HASP_drivers_latest.zip
Make sure your hardware key is inserted into a USB port on the PC.
Unzip the downloaded drivers from step 1.
1. Inside the resulting folder Sentinel_HASP_Run-time_setup, double click the file HASPUserSetup.exe.
Reboot your PC. At this point, a red light should be glowing on the end of the hardware key; if not, contact eXtyles technical support.

You can then continue to install eXtyles as described here.

On this page

Applies to:

Only applies to certain configurations of:

If you are using Windows 11 and need to install HASP drivers to use eXtyles you will need to follow these steps.

1. Download the Legacy Drivers from Thales’s website.

2. In File Explorer, right click on Sentinel_LDK_Run-time_cmd_line.zip and select extract all… . Accept the default directory.

3. Open a Command Prompt

a. Select Start Menu > Windows System > Command Prompt or

b. In the “Tray” of Windows in the Search Box, type cmd and hit Enter

4. Change the directory to the extracted location of haspdinst.exe. This is most likely to be in this directory:

C:\Users\{username}\Downloads\Sentinel_LDK_Run-time_cmd_line\Sentinel_LDK_Run-time_cmd_line

Note the nested, duplicate directory name!

The change directory command will look like this:

C:\Users\{username}> cd Downloads\Sentinel_LDK_Run-time_cmd_line\Sentinel_LDK_Run-time_cmd_line

5. Type and run the following command at the prompt:

C:\Users\...\...Run-time_cmd_line> haspdinst.exe -i -fi -kp -fss -v -ld

6. Proceed to install eXtyles.